INSTRUCTIONS

General

• When operating outdoors do not activate with winds in excess of 15 MPH. 
• Do not operate the unit during inclement weather conditions.
• Refer to programming instructions to operate the remote, motor 
• Before using, insure the bracket contained with the unit is firmly secured to the wall
• Do not retract the flag while it is draped over the canister. 

Changing out the Flag

Step 1: Unfurl the flag while in the flag mount.
Step 2: Remove the flag mast and unit from the flag mount and lay the entire unit on a flat surface.
Step 3: Using a Phillips head screwdriver remove the two screws holding the the flag guide which, the metal device guiding the flag edge.
Step 4: Remove the Flag from the tube.
Step 5: Push the pin inside the bracket slowly and slide the tube downward.
Step 6: Lift the tube up to release the pronged edged carefully slide the tube out with motor and antenna wire out of the canister.
Step 7: Attach the flag aligning the velcro strip in a straight and taught manner.
Step 8: Thread the flag guide to the edge of the flag and screw the flag guide back on the plate using the two screw with a Phillips head screw driver.
Step 9: Insert the tube by threading the antenna wire in the hole and the proceed end first; than push the spring pin on the other side and slide up until the pin is in the locked position.
Step 10: Place the entire unit back into the flag mount.
Step 11: Operate the remote to insure the flag is at the desired length.
Step 12: If an adjustment is required refer the programming instructions included with the remote control device.